FT Injector 230 lb/h GEN 3 - EV1 Connector — Set of 4

The FT Injector 230lb/hr (2415cc/min @ 43.5 psi) is a high impedance fuel injector from the FT Injector family, no Peak and Hold driver is required. The FT Injector is compatible with all available fuels (gasoline, ethanol, alcohol, nitromethane, nitropropane, MTBE and ETBE). Featuring EV1 connectors with silver plated terminals for superior conductivity and corrosion resistant internal components.

FEATURES

• REAL flow, all injectors are tested, and calibrated to ensure linearity, repeatability and accuracy for all cylinders.
• It has internal components resistant to corrosion, guaranteed by the salinization test carried out on all raw material used.
• Compatible with any type of fuel (Gasoline, Ethanol, nitromethane, nitropropane, MTBE and ETBE)
• Compatible with any ECU on the market
• FuelTech warranty and support
• Project developed prioritizing the quality and durability of the injector.

TECHNICAL DESCRIPTION:

• High Impedance
• Coil resistance: 7.4 - 8.4 ohms
• Ingress protection rating: IP67 / NEMA6

DIMENSIONS:

1 - Overall height - 74 mm (2.69”)

2 - Overall width - 18 mm (0.71”)

3 - Top O-ring diameter - 14.50 mm (0.56”)

4 - Tip - 4.1 mm (0.16”)

5 - Bottom O-ring diameter - 14.50 mm (0.56”)

PRODUCT CONTENT:

• 4 FT Injectors
• 1 Manual

WARRANTY: 90 days

Product Video

More FuelTech tech videos →

GEN 3 injector, part number 5010119164. Same 230 lb/h flow, EV1 connector and high impedance (no peak and hold driver needed), so it swaps right in for the earlier 230 lb/h. New internal coil, spray pattern and needle geometry with no internal filter give a shorter dead time and better idle and low-RPM control. Use the GEN 3 injector data in the ECU, not an older calibration.