Pulsar XT for 2020-2024 Jeep 3.0L Diesel

The intuitive mobile app gives you control over TPMS settings, can disable your Auto Start/Stop, modify engine high idle settings, and even do a manual DPF Regen cycle if needed. Giving Jeep owners even more control, Pulsar XT has the ability to enable your rear locker in 2wd for more fun in the sand or snow, front + rear lockers in 4wd High, and even disconnect your Rubicon's sway bar up to 45mph in any t-case mode. Frustrated your factory Traction Control still limits your off-road ability? Pulsar XT will completely kill that Traction Control system, electronic stability and disable ABS for the ultimate off-road experience at the push of a button in the app. Pulsar XT will also allow you to check and clear DTC's, check emissions readiness, reconfigure your lighting options, and calibrate for transfer case ratio changes. The device also offers cold engine protection so no power is added until you're up to operating temperatures, keeping your engine safe.

Features

• Supports 2020-2023 Jeep Wrangler and Gladiator 3.0D
• Enable/disable Auto Start/Stop
• Read and clear DTC's
• Gear ratio adjust for 2.72-5.00
• Traction Control Disable
• Configure Lighting like Fog Beams with High Beams, License Plate Off with Reverse, Daytime Running off with Turn Signal
• Engine High Idle - Command engine idle from 900-2000rpm while in park with steering wheel controls
• Manual DPF Regen
• Axle Lockers in 2wd and 4-High
• Swaybar Disconnect in 2wd, 4-Lo and 4-High
• User adjustable power levels on the fly through steering wheel controls
• Adds up to 38hp/73tq at peak
• Improves economy, throttle response, low end torque, and performance
• 7 throttle sensitivity settings adjustable in the app for each power level
• Smartphone App control for Android and IOS
• Calibrate for tire sizes 26-40"
• Manual Engine Fan Control
• Enable/disable TPMS or adjust warning threshold

Documentation

• Installation instructions — d10029700 rev00 (PDF)