Transmission Controller

The PCS TCM2000 is a fully programmable standalone transmission controller — it takes an electronic automatic out of the factory computer’s hands and puts shift points, shift firmness and converter lockup under your control, tuned from a laptop.

Outputs

• 6 × 3.5 A programmable drivers, active high or low, with three switchable between digital and PWM — fully programmable frequency and duty cycle
• Stepper motor programmable
• Short circuit, over-current and thermal shutdown protection, with built-in failure diagnostics
• Programmable frequency speed output, usable as a speedometer drive or speed sensor replacement (20 mA limit, ±10 V)

Inputs

• 6 × 0–5 V analog, 10-bit, EMI protected and noise filtered, with resistors on inputs 5 and 6 for direct measurement of resistance sensors
• 16 × programmable digital inputs, active high or low
• 4 × programmable speed inputs with user-set high-pass filters and trigger levels — magnetic, hall-effect or logic level

Communication. CAN 2.0b at up to 1 Mb/s with user-definable messages, plus RS-232 at 38.4 kbps for datalogging and PC communication.

Built for the environment it lives in. −40 to 105°C, 8 to 27 volt operating range, reverse battery and voltage spike protection. Case and circular connector are both sealed to IP65. Anodized aluminium and high-strength plastic, 25 MHz military qualified microcontroller, built to IPC-A-610 Class 3 in an ISO-9002 facility, burned in and tested at the factory, and flash upgradeable in the field. 1.2 lb, 5.9 × 4.15 × 1.75 in. One year warranty, parts and labour.

Getting a transmission to shift the way you want is the half of a swap people underestimate. Call us on 928-706-6112 and we will work out what your combination needs.

Documentation

• TCU Manual v.2.1 — TCU installation instructions and user's guide. (PDF)